| All CANbus controlled engines and applications |
Attention, Product`s end of life...while stocks last!
|
Features
CANmonitor reads out engine parameters which are sent digitally by the CANbus SAE J1939 protocol
The data is displayed on analogue meters, LEDs and/or optionally CAN-MD
Engine speed adjustment by switches and pushbuttons
Ramp function for warming up and cooling down time
Two years warranty
Connection of up to four analogue display instruments
Up to six LEDs to visualise failures quickly, e.g. fuel pressure or engine oil level
Technical Data
Inputs
Battery 30 and switch battery 15
Starter 50 for excitation resistor
Diagnostics EMR/ ECL etc.
Charge pilot lamp
Adaptation of engine speed
Engine speed adjustment, increase
Engine speed adjustment, decrease
Preheat lamp
Service lamp
Display external failures
Sensor 4 – 20mA
Outputs
4 outputs for analogue gauges
Adjustment of engine speed
4 outputs for generator excitation D+, engine on,
switch for term. 15
Operating voltage 10 to 32 V
Voltage peak UB 2ms, 200V
Interference voltage UB 6Vss, 50Hz
Current consumption max. 200mA (ignition on), < 5mA (ignition off)
All outputs are short circuit protected
installation dimensions 120mm x 80mm
Temperature range -40 to +85°C
